31
GB
Failure to follow the above instruction may
cause people or animals to suffer eye
injuries and/or to lose their sight� Even a
weak LED light beam is capable of causing
eye damage�
z
Assembly
Please note:
remove all packaging material
from the product� Protect easily damaged
surfaces before setting up the product�
Please note:
fully unwind the mains power
cable� Route the mains power cable in such
a way that nobody can tread on it or trip
over it�
z
Setting up the tripod stand
Loosen the hand screw (tripod base)
8
by
turning it anticlockwise�
RISK OF TRAPPING/PINCHING!
To
avoid injuries when unfolding the legs, take
care not to put your hands between the
tripod base and the legs�
Take hold of the tripod base
6
at the point
where the legs are attached, level with the
hand screw (tripod base)
8
, and press it
downwards so that the legs fold out� Once
the tripod base
6
is pushed down as far
as it will go and the legs are fully extended,
re-tighten the hand screw (tripod base)
8
by turning it clockwise (see Fig� A)�
z
Setting the height of the
tripod stand
Loosen the hand screw (telescopic pole)
9
by turning it anticlockwise (see Fig A)�
Set the tripod stand
5
to the desired
height by pulling up or pushing down the
telescopic pole
4
(see Fig� A)�
Firmly tighten the hand screw (telescopic
pole)
9
by turning it clockwise to fix the
tripod stand
5
at the desired height (see
Fig� A)�
z
Mounting the work
floodlight on the tripod
stand
RISK OF ELECTRIC SHOCK!
Unplug the mains plug from the
power outlet socket before mounting
the floodlight on the tripod stand.
Open the mounting clamp
11
at the top of
the telescopic pole
4
so that the locking
handle is facing towards you (see Fig� D)�
Loosen the hand screw (folding bracket)
13
so that you can fold the floodlight and the
inner bracket to the rear out of the way�
Then locate the floodlight
2
centrally on
the open mounting clamp
11
with the aid
of the handle
1
(see Fig� D)�
Please note:
make sure that the back of the
floodlight is facing the locking handle.
Otherwise it is not possible to close the
mounting clamp�
Please note:
take care to ensure the mains
power cable is not trapped�
Fold down the two rear clips of the
mounting clamp over the outer folding
bracket of the floodlight, which is now
seated in the mounting clamp (see Fig� D)�
Next, fold down the front clip of the
mounting clamp over the two rear clips
previously folded down, so that they
interlock (see Fig� D)�
Press down the locking handle of the
mounting clamp
11
to fix the mounting
bracket in place (see Fig� D)�
Now position the floodlight and inner
folding bracket centrally over the mounting
clamp and fix them in position by
tightening the hand screw
13
(see Fig� D)�
z
Operation without tripod
stand
RISK OF ELECTRIC SHOCK!
Unplug the mains plug from the
power outlet socket before
attempting to alter the position of the
