Parkside PAHE 20-Li B2, Оригинальное руководство пользователя

Страница: 19 / 160

19
CY GB
place where the branch section lands.
• Saw the lower branches of the tree off
first in order to make it easier for the
branches that have been cut off to fall
to the ground.
• After the cut is completed, the weight
of the saw increases abruptly for the
operator, as the saw is no longer
supported on the branch. There is a
danger that you will lose control of the
device.
• You should only pull the saw out of the
cut with the saw chain running in order
to avoid jamming.
• Do not saw with the tip of the cutting
equipment.
• Do not saw the bulge at the base of
the branch because this will prevent the
tree from healing.
Maintenance/Cleaning
Warning! Risk of injury by
dangerous moving parts!
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Remove the rechargeable battery
from the device before cleaning
and maintenance.
Wear gloves when handling the
saw chain.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
• Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the se-
cure seating of the bolts in the cutter bar.
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
Cleaning
Remove the rechargeable battery
from the device before cleaning.
• Clean the appliance after each use.
Clean the motor housing with a damp
cloth or a brush. The device must neit-
her be sprayed with water nor be put
into water.
• Keep the ventilation channels of the de-
vice clean. Use a damp cloth or brush
to do this.
• Do not use any cleaning agents or
solvents. This could damage the device
irreparably. Chemical substances may
attack the plastic parts of the device.
Service intervals
Carefully perform the maintenance tasks
listed in the following table on a regular
basis. Regular servicing of your unit will
extend the life of your equipment.
Additionally, you will achieve optimum cut-
ting performance and prevent accidents.