Parkside PABS 16 B3, Инструкции по эксплуатации и безопасности

Страница: 10 / 43

Charging status LEDs
Green LED
continuously lit
Charger ready
Red LED
continuously lit
Battery pack charging
Green LED
continuously lit
Battery pack fully charged
Red LED flashing Battery pack defect
Green LED flashing Battery pack too cold or warm
Q
Checking the battery charging
level
o
Press the on / off button
7
to check the
charging level of the battery pack
8
. The
status / remaining charge will be shown on
the battery charging level indication lights
5
.
Green / red /
orange
maximum battery charging level
Red / orange medium battery charging level
Red
low battery charging level
o
Charge the battery pack 8 before operation
when it is at medium or low battery charging
level.
Q
Operation
CAUTION! RISK OF INJURY!
u
Keep your hands away from the tool when
the product is in operation.
Q
Changing accessories
CAUTION! RISK OF INJURY!
Accessories can be sharp and may
become hot during use. Always wear
protective gloves when handling
accessories!
This product is equipped with an automatic spindle
lock to open or close the spindle with the chuck
sleeve
1
.
1. Push the rotation control switch 6 to the centre
position to lock the on / off switch
7
.
2. Turn the chuck sleeve
1
clockwise to open the
spindle.
3. Insert a suitable accessory into the spindle as
deep as required.
4. Hold the accessory in position and turn the
chuck sleeve
1
counter clockwise to close the
spindle.
5. Push the rotation control switch
6
to the
position required for your application.
6. After short operation, switch the product off and
ensure the accessory is still properly fastened.
Q
Speed control
Speed selector
WARNING!
u
Do not actuate the speed selector unless the
spindle has come to a complete stop!
1. This product is equipped with a two speed
gearbox. The 1
st
gear is designed for screw
driving operations with low speed and high
torque, while the 2
nd
gear is designed for drilling
operations with high speed and low torque.
2. Preselect the gear for your application by
moving the speed selector
3
.
1
st
gear: Speed selector switch
3
in position 1.
2
nd
gear: Speed selector switch
3
in position 2.
On / off switch
The on / off switch
7
is combined with a speed
control. The speed increases or reduces depending
on how hard it is pressed. This allows you to change
the speed during operation.
Q
Rotation control
WARNING!
u
Do not actuate the rotation control switch unless
the spindle has come to a complete stop!
o
Change the direction of rotation by pushing the
rotation control switch
6
towards left or right.
o
Push the rotation control switch
6
to the centre
position to lock the on / off switch
7
(e. g. when changing accessories,
transportation).
12 GB / IE / NI / CY