Parkside PABS 16 A1, Оригинальное руководство пользователя

Страница: 9 / 54

6 PABS 16 A1
GB
CY
Supplementary notes
■ Secure the workpiece. A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■ Hold the power tool firmly. High reaction
moments can occur for brief periods while
tightening and loosening screws.
■ Switch the power off immediately if the tool
blocks while in use.
Be prepared for high reac-
tion moments as these can cause kickback.
■ While working on the appliance, transporting
it or storing it, always set the rotation direc-
tion switch to the centre position (lock).
This prevents the power tool from starting up
unintentionally.
■
CAUTION, POWER CABLES! DANGER!
Ensure that you are not likely to contact power,
gas or water supply lines when you are working
with the power tool. If necessary, check with
a service line detector before you start to cut
or drill into a surface.
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger.
■ Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack to the rapid battery
charger (see Fig. A).
♦ Insert the power plug into the socket. The control
LED will light up red and indicates the charg-
ing process.
♦ The green control LED indicates that the
charging process is complete and the battery
pack is ready.
♦ Insert the battery pack back into the appli-
ance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Move the rotation direction switch to the
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack:
♦ Press the release button and remove the
battery pack.
Checking the battery charge level
♦ Press the ON/OFF switch to check the status
of the battery (see also main diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
♦ GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery