Parkside PABK 60 B3, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 31 / 119

28 GB/IE
Initial use General safety instructions for pneumatic tools / Before Use / Initial use
replaced by the manufacturer
or their service department or a
similarly qualified person, in
order to avoid hazards.
Store the device in a dry envi-
ronment if it will not be in use for
an extended period of time.
Make sure that the connection
cable is not hanging over a cor-
ner and is not stretched taut; oth-
erwise there is a risk of injury.
Do not use the mains lead for
any purpose for which it was not
intended, e.g. to carry the prod-
uct, to hang it up or to pull the
mains plug out of the mains
socket.
Never pull on the mains cable to
remove the mains plug from the
socket.
Do not use electronic tools in a
wet or damp environment; do
not expose them to rain or high
levels of moisture.
Never connect electrical tools
near highly flammable liquids or
gases.
If you are working outside, only
use an extension cable that is
explicitly intended for that use.
Product-specific safety
instructions
CAUTION! HAZARD
OF BURNS!
The
Compressor will warm up when
it used for a long time. Therefore
always use the handle on the
device to move it. Never touch
the device itself!
Attention! The casing of the
airbrush compressor may become
hot during use. Do not touch hot
surfaces, in order to prevent
burns.
Never leave the device in opera-
tion unattended. Built-up heat
generated by the device can be
a source of danger.
Before Use
Check that all parts of the device are in perfect
condition.
Check whether your available voltage is com-
patible with the compressor.
Note:
you will find the intended mains voltage
on the type plate of the device.
Initial use
Note:
the device slides around with correct use on
smooth surfaces. This can be prevented by gently
pressing down the device.
Clean dusty surfaces so that the suction cups can
grip well. Otherwise a slight shift in position is
possible.
285126_Airbrush-Set PABK 60 B3_content_OS.indd 28 19.06.17 16:14