Parkside PABH 20-Li B2, Инструкция по эксплуатации

Страница: 12 / 75

PABH 20-Li B2 ■ 8
│
GB
│
IE
│
NI
Fitting an SDS tool/Keyless chuck
WARNING!
►
Do not use the quick-action drill
chuck in hammer drilling or chiselling
operation!
♦ Grease the tool holder slightly before
inserting the tool.
♦ Insert the tool rotatingly into the tool holder
until it clicks into place.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing an SDS tool
♦ Pull the locking sleeve backwards and
remove the tool.
Operation
Select operating mode
■ Use the “Drill/hammer drill” switch to select
the operating mode of the power tool.
NOTE
► Change the mode only when power tool is
switched off. Otherwise, the tool could be
damaged.
♦ To change the operating mode, turn the “Drill/
hammer drill” switch to the desired position.
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF
Setting the rotation direction
NOTE
► Operate the rotation direction switch only
when the appliance is at a standstill.
■ You can use the rotation direction switch to
change the direction of rotation of the power
tool. This is not possible, however, while the on/
off switch is pressed in.
Clockwise
♦ For drilling and screwing in screws, turn the
rotation direction switch to the left as far
as the stop.
♦ Anti-clockwise
♦ For undoing and removing screws and nuts, turn
the rotation direction switch to the right as
far as the stop.
IB_360585_PABH20-LiB2_LB6.indb 8 28.12.2020 14:33:21