Parkside PABH 20-Li B2, Инструкция по эксплуатации

Страница: 11 / 75

PABH 20-Li B2 GB
│
IE
│
NI
│
7 ■
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always pull out the plug before you remove
the battery pack from or connect the
battery pack to the charger.
► Never charge the battery pack when
the ambient temperature is below 10°C or
above 40°C.
♦ Connect the battery pack to the high-speed
battery charger (see Fig. A).
♦ Insert the power plug into the socket. The con-
trol LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack is
ready.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Push the rotation direction switch into the
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Operation
NOTE
► Push the rotation direction switch into
the middle position before carrying out
any work on the power tool (e.g. mainten-
ance, tool-changing, etc.) as well as during
carriage and storage of the power tool.
Unintentional activation of the On/Off
switch can result in injury.
Selecting a tool
■ For hammer drilling, you will need an SDS-plus
drilling tool.
■ For standard drilling in wood, metal, ceramics
and plastic, you can use an appropriate SDS-
plus drilling tool or a tool with a hexagonal
shank.
■ For screwing, use the screwdriver bits that
you can attach using the SDS bit adapter .
Tool-changing
■ You can use the SDS-plus tool holder to
change tools quickly and easily without the
need for any additional tools.
■ The SDS-plus drilling tool moves freely (depend-
ing on the system). This leads to a radial run-out
deviation while idling. This has no effect on the
accuracy of the drill hole as the drill centres
itself during drilling.
■ The dust protection cap largely prevents the
entry of drilling dust into tool holder during
operation. Ensure that the dust protection cap
does not get damaged when fitting tools.
NOTE
► A damaged dust protection cap must
be replaced immediately. We recommend
having this done by a customer service
workshop.
IB_360585_PABH20-LiB2_LB6.indb 7 28.12.2020 14:33:21