Parkside P-SZ 250, Инструкции по эксплуатации и безопасности

Страница: 7 / 32

GB
7
1. Introduction

Important!
When using equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete
operating manual with due care. Keep this
manual in a safe place, so that the information
is available at all times. If you give the
equipment to any other person, give them
these operating instructions as well.
We accept no liability for damage or accidents
which arise due to non-observance of these
instructions and the safety information.
2. Safety information

CAUTION!
Read all safety regulations and
instructions.
Any errors made in following the safety
regulations and instructions may result in an
electric shock, fire and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Always check that the mains voltage is
identical to the voltage quoted on the rating
plate. In the event that the mains voltage is
not suitable, it may cause the machine to
work abnormally and thus result in personal
injury.
The power supply must be earthed and be
secured by a residual current operated
circuit breaker (RCCB).
Do not attempt to lift loads that exceed the
rated load.
Use the machine only for the purpose for
which it is designed. Never lift personnel
using the cable hoist.
Do not pull the power cable in order to pull
out the plug. Protect the power cable from
heat, oil and sharp edges.
Never attempt to raise fixed or jammed
loads.
Pull out the plug when the cable hoist is not
in use.
Keep children and other unauthorized
persons away from the machine.
Do not pull loads sideways or from one
side. Do not allow the load to swing.
Ensure that the hook moves in the same
direction as shown on the pushbutton.
Check the cable hoist at regular intervals for
signs of damage. The pushbutton must be
in good condition.
Have repair and servicing work carried out
only by authorized workshops by a trained
electrician. Repair work must only be
carried out by a trained electrician,
otherwise the machine may cause
accidents.
Do not switch the machine on and off
quickly (inching mode).
Always concentrate fully when operating
the cable hoist.
Do not stand or work under the raised load.
It is not permitted to lift fixed or jammed
loads.
3. Layout and items supplied
(Fig. 1-2)
1. Fastening bar
2. Fastening hole for hook
3. Drum
4. Lever for maximum cable length
5. Automatic stop mechanism lever
6. Steel cable
7. Cut-out weight
8. Hook
9. Emergency Stop switch
10. Pushbutton
11. Remote control
12. Power cable
13. Control cable
14. Motor
15. Return roller
16. Additional hook
Anleitung_2255122:_ 25.08.2009 8:25 Uhr Seite 7