Parkside KH 3131 POWER PLANER, Руководство пользователя

Страница: 13 / 72

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
13
k
13 13
CHANGING OR REVERSING THE PLANER BLADES
WARNING: Before doing any work on the planer always pull out the plug from the mains.
IMPORTANT ADVICE:
Do not unscrew the two hexagonal socket headed screws. They adjust the height of the cutting block.
Adjustment is only required if you wish to change to another planer blade type e.g. a profiled blade.
HSS reversible blades are fitted as standard at the works. When you change blades, always change
both blades to avoid any imbalance. When they become blunt, the PARKSIDE reversible blades can be
changed without any height adjustment of the cutting block being necessary
1) First unscrew one cutting block only so that you can use the works-mounted second cutting block
as an aid to setting up later.
2) Unscrew the three screws in the cutting block using the supplied open spanner.
3) Take the cutting block out of the planing roller.
4) Slide the planer blade sideways out of the cutting block.
NOTE: The cutting block can also be dismantled, e.g. for cleaning.
5) Re-assembly with a reversed or new blade is done in reverse order.
6) Check again for safety:
- the position of the planer blade in the cutting block
- the balanced and secure seating of the cutting block and the 3 fixing screws
- that the height adjustment is correct (2 hexagonal socket headed screws).
7) Planer blades can be obtained from the service address indicated (see guarantee).
CHANGE TOOTHED BELT
Unscrew the screws in the cover and take off the toothed belt cover . Cut through the toothed belt
with side-cutting pliers or a knife and remove the severed toothed belt. Always clean off any dirt or
debris from the pulley and the drive wheel before installing the new belt.
Place the new toothed belt on to the drive wheel and push the belt over the large pulley wheel whilst
turning it.
Put the toothed belt cover
back in place and fasten with the screws.
MAINTENANCE AND CARE
Clean the planer regularly. For the best results do this straight after the work has been completed.
Do not allow liquids to get inside the planer. Use a soft cloth for cleaning the housing. Do not use
petrol, solvents or cleaners that might attack the plastic. Air vents must always be clear and clean.
www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
13
t
BA_Ident.-No._PEH950-102003-1 21.01.2004 13:33 Uhr Seite 13