Parkside KH 3038 SCROLL SAW, Инструкции по эксплуатации и безопасности

Страница: 8 / 46

8 GB/IE
J
Where there are connection points provided
for vacuum dust extraction please use them,
and ensure they are working properly.
11. Do not use the mains lead for
purposes for which it was
not intended.
J
Do not use the mains lead to pull the plug out
of the mains socket. Protect the mains lead
from heat, oil and sharp edges.
12. Secure the workpiece.
J
Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it with
your hand.
13.
Avoid placing your body in an
unnatural position.
J
Keep proper footing and balance at all times.
14.
Look after your tools carefully.
J
Keep cutting tools sharp and clean. This way
you will work more safely and achieve better
results.
J
Follow the advice on tool lubrication and
consumables replacement.
J
Check the condition of the mains lead on your
electrical power tool regularly and have any
damage repaired by a competent specialist.
J
Check the condition of extension leads regu-
larly and replace them if they are damaged.
J
Keep handles and hand grips clean, dry and
free of oil and grease.
15. Pull the mains plug out of the
mains socket.
J
Do this if the electrical power tool is not being
used, before carrying out maintenance tasks
on the electrical power tool and whenever
you are changing inserted tools, e.g. saw
blades, drills or router bits.
16.
Make sure that no spanners, keys
etc. are left attached.
J
Check before switching on that all spanners,
keys and setting tools have been removed.
17. Avoid unintentionally starting
up the device.
J
Check that the switch is set to OFF on the de-
vice when the mains plug is inserted into the
mains socket.
18. Using an extension lead for
working outdoors.
J
When working outside, always use an approved
and appropriately labelled extension lead.
19.
Remain alert.
J
Watch what you are doing. Proceed with cau-
tion. Do not use electrical power tools if you
cannot concentrate.
20. Check the electrical power tool
for damage.
J
Before the electrical power tool is used, care-
fully check the safety equipment and any
slightly damaged parts to see that they are still
working properly.
J
Check that all moving parts on the tool are
working properly, can move freely and are not
damaged. All parts must be correctly attached
and fulfil all the requirements necessary to allow
the electrical power tool to operate properly.
J
Damaged safety equipment and components
must be properly repaired or replaced at a com-
petent electrical equipment repair centre unless
otherwise indicated in the operating instructions.
J
Damaged switches must be replaced at a
Customer Service Centre.
J
Never use an electrical power tool that cannot
be switched on and off properly.
21. ATTENTION!
J
The use of inserted tools and accessories other
than those recommended by the manufacturer
could lead to you being injured.
22. Have your electrical power tool
repaired at an electrical equipment
repair specialist.
J
This electrical power tool complies with the
relevant safety regulations. Repairs may only
be carried out by a specialist electrical repair
centre using original spare parts, otherwise in-
jury could occur to the user.
Safety advice relating
specifically to scroll saws
J
Ensure that the scroll saw stands on a level,
horizontal surface.
J
Do not touch the mains lead if it becomes dam-
aged or cut through while you are using the
device. Pull the plug out of the mains socket im-
mediately and have the device repaired by a
Safety advice
33383_SCROLL SAW_Dekupiersaege_Content_LB3 (ohne GR).indd 8 23.07.09 11:31