GB
- 13 -
6. Before starting the
equipment
Caution:
Be sure to read the following information before
you use your cordless screwdriver for the fi rst time:
1. Only charge the battery pack using the char-
ger (11) supplied.
2. Only use screwdriver bits which are in perfect
working order and appropriate.
3. When screwing into walls or partitions, test
these for electrical, gas or water connections.
7. Operation
7.1 Charging the battery pack (Fig. 1)
The battery pack is protected from exhaustive di-
scharge. An integrated protective circuit automati-
cally switches off the equipment when the battery
pack is fl at. In this case the bit chuck (1) will cease
to turn.
Caution:
Do not press the ON/OFF switch (9) any more,
if the protective circuit has actuated. This may da-
mage the battery pack.
1. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger (11) in the
plug socket and connect the charging cable
(12) to the charging connection (8). The char-
ging process starts as soon as the charging
cable is connected to the charging connec-
tion.
2. The charging control lamp (7) indicates that
the battery is being charged.
3. The charging control lamp (7) goes out when
charging is completed.
Caution:
The handle may become a little warm during the
charging process. This is normal.
If the battery pack fails to charge, please check
•
whether there is voltage at the socket-outlet.
•
whether there is good contact at the charging
contacts of the battery charger (11).
If the battery still fails to charge, send
•
the battery charger (11)
•
and the screwdriver
to our customer services department.
Timely recharging of the battery pack will help to
prolong its lifespan. You must recharge the bat-
tery pack when you notice that the power of the
screwdriver drops.
7.2 Clockwise/Counter-clockwise chan-
geover switch (Fig. 2/Item 10)
The clockwise/counter-clockwise changeover
switch (10) above the ON/OFF switch (9) is
for setting the direction of rotation of the cord-
less screwdriver and for preventing the cordless
screwdriver from being switched on inadvertently.
You can select between clockwise and counter-
clockwise rotation.
Important.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe
this point, the gearing may become damaged.
When the clockwise/counter-clockwise changeo-
ver switch (10) is in the middle position, the ON/
OFF switch (9) is blocked.
Direction
Switch position
Clockwise
“R” pressed
Counter-clockwise
“L” pressed
7.3 ON/OFF switch (Fig. 2/Item 9)
Press the ON/OFF switch (9) to switch the cord-
less screwdriver on. Release the ON/OFF switch
to switch off the tool.
7.4 LED lamp (Fig. 2/Item 2)
The LED lamp (2) can be used in poor lighting
conditions to illuminate the area where you want
to screw. To switch ON, press the switch (4) and
to switch OFF, press the switch (4) again.
Anl_4513424.indb 13
Anl_4513424.indb 13
25.10.12 18:39
25.10.12 18:39
