Parkside 384506 2107, Руководство пользователя

Страница: 12 / 53

PWS 230 D4 ■ 8 │
GB
│
IE
│
NI
│
CY
Permissible accessories
Max. diameter Ø (mm)
Max. thickness (mm)
Thr
ead siz
e (mm)
Speed (rpm)
Cir
cumfer
ential speed
(m/s)
Tool
Blade guar
d
Cutting disc 230 3 M14 6500 80
Two-hole assembly
spanner
Yes
Roughing disc 230 6 M14 6500 80
Two-hole assembly
spanner
Yes
Storage and handling of the recom-
mended accessory tools
■ Grinding tools are to be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical
damage or environmental influences (e.g.
moisture).
Working procedures
NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■
Move the angle grinder with moderate pres-
sure back and forth over the workpiece.
■ For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs
that are approved for a circum-
ferential speed of not less than 80 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece! Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■
Always switch off the appliance before
putting it away and wait for the appliance to
come to a complete standstill.
■ Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out.
Move it into the OFF position. This
prevents an uncontrolled restart.
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle must be mounted on
the appliance for all work.
■ Materials containing asbestos may not be
processed.
Asbestos is a known carcinogen.