Parkside 367471 2101, Перевод оригинальной инструкции

Страница: 9 / 104

PBH 800 A1 ■ 6 │
GB
│
IE
Operation
Additional handle
NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ The gripping position of the additional
handle can be varied.
Turn the additional handle clockwise and
pull the additional handle off the appliance
a little way.
♦ Turn the additional handle to the desired
position.
♦ Now, slide the locking positions on the addi-
tional handle over the two locking pins on
the spindle of the appliance.
♦ Retighten the additional handle afterwards
by turning it in an anticlockwise direction.
NOTE
► Turn the additional handle into the various
locking positions depending on your working
position. Undo and lock the additional
handle as described previously.
Depth stop
♦ Undo the screw on the depth stop .
♦ Insert the depth stop into the additional
handle .
♦ Ensure that the toothing on the depth stop
is facing downwards.
♦ Pull the depth stop out until the distance
between the tip of the drill and the tip of the
depth stop with the required drilling depth.
♦ Tighten the screw on the depth stop to
lock the depth stop into place.
Fitting/removing a tool
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool
♦ Before fitting a tool, grease the tool holder
lightly with machine grease.
♦ Place the tool in the tool holder so that it
rotates until it locks automatically.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool
♦ To release the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
for hammer drilling or chiselling!
♦ Set the function selector switch to the drill
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ Place the quick-release chuck in the tool
holder so that it rotates until it locks auto-
matically.
♦ Check that the tool is properly locked by
pulling it.
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck , pull the
locking collar backwards and remove the
quick-release chuck .