Parkside 344907_2004, Перевод оригинальной инструкции

Страница: 10 / 38

PFS 400 A1 GB
│
IE
│
NI
│
CY
│
7 ■
Selecting a spray profile
Setting the spray volume
♦ Turn the spray volume adjusting wheel to
the desired position:
(–) = minimum spray volume
(+) = maximum spray volume
NOTE
► We recommend starting at the minimum
setting.
Selecting a jet type
♦ Undo the union nut .
♦ Turn the protruding parts of the nozzle head
so that they point to the desired symbol on the
spray unit .
The appliance has the following settings:
▯ round jet
vertical flat jet
horizontal flat jet
♦ Re-tighten the union nut .
Maintenance and cleaning
WARNING! Disconnect the mains
plug during breaks and while doing
maintenance work on the appliance.
ATTENTION!
► Never immerse the paint spray gun
completely in solvent.
NOTE
► Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot be
guaranteed.
■ Wear suitable gloves when cleaning.
■ After every use, squirt water through the
appliance.
♦ To clean the spray unit , nozzle head ,
nozzles and the spray holes inside, use the
supplied cleaning brush , cleaning needle
or a cloth. Never use petrol, solvents or
cleansers which can damage plastic.
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦ Oil all moving parts from time to time.
♦ Do not use any silicon-based lubricants.
♦ Store the appliance only in dry interior rooms.
Cleaning/replacing the air filter
Check the air filter regularly, otherwise malfunc-
tions may occur.
♦ Remove the screws from the air filter cover .
♦ Remove the air filter cover .
♦ Remove the air filter and examine it for
contamination.
♦ If necessary, shake out the air filter and
clean it under running water. Leave the air
filter to dry.
NOTE
► If necessary, replace the air filter with the
replacement air filter .
♦ Proceed in reverse order in order to reassemble
the appliance.