Parkside 336931 2001, Перевод оригинальной инструкции

Страница: 23 / 91

PMB 1100 B2 GB
│
IE
│
19 ■
Mounting the band saw on the swivel arm
If you plan to operate the appliance using the saw
table , proceed as follows:
♦ Attach the swivel arm using the 3 long wing
screws supplied in the corresponding holes
of the appliance housing (see fig. E on the
fold-out page).
NOTE
► It is possible that the nuts
21a
are a little too
tight on delivery. Loosen the nuts 21a a little
with a 19 mm wrench.
► Tighten the nut 21a from time to time with a
19 mm wrench if the swivel arm has too
much play.
WARNING!
► The band saw may only be used without
the saw table if the user has firm, steady
footing. The workpiece must also be
secured against slipping, for instance on a
workbench.
► Make sure at all times that the power cord
can not get near the saw blade.
► If you want to use the appliance with the saw
table, attach the power cable with the cable
holder
A
as shown in the following
diagram:
A
B
► For any other use, the cable must be routed
using the cable holders
A B
so that the
cable can never get into the sawing/working
area or any other hazardous area.
Making settings
Adjusting the handle
♦ To adjust the handle , loosen the wing
screw on the handle.
♦ Turn the handle to the required position.
♦ Retighten the wing screw .
Using the vice
♦ Turn the handle on the vice clockwise to
clamp the workpiece.
♦ Turn the handle on the vice anticlockwise
to unclamp the workpiece.
NOTE
► You can also flip the quick release
15a
upwards
in order to adjust the vice setting more
quickly. Fold the quick release
15a
back down
again to fix the vice in place. After this, use
the vice handle to make fine adjustments.
Transport restraint
♦ To release the position, pull out the locking
pin so you can lower the band saw.
♦ Swivel the band saw downwards and push in
the locking pin . Now you can easily trans-
port the band saw together with the saw table.
Setting the cutting angle (mitre angle)
♦ Undo the cutting angle adjustment by turning
it anticlockwise.
♦ Set the required cutting angle using the angle
provided.
♦ Retighten the cutting angle adjustment by
turning it clockwise.