Parkside 331116_1907, Перевод оригинальной инструкции

Страница: 26 / 40

PET 25 C3 GB
│
MT
│
23 ■
Appliance-specific safety
instructions for electric staple
guns
■ Always check that the power tool contains
staples.
Careless handling of the staple gun can lead
to unexpected ejection of staples which could
cause injuries.
■ Never aim the power tool at yourself or other
people in the vicinity.
Unintended triggering
will cause a staple to shoot out, which can lead
to injuries.
■
Do not activate the power tool until it is
pressed firmly against the workpiece
. If the
power tool is not in contact with the workpiece
the staple can rebound off the fastening point.
■
Disconnect the power tool from the mains
or battery if a staple becomes jammed in
the power tool.
If the staple gun is connected
to a power source, it could be unintentionally
activated while removing a jammed staple.
■ Be careful when removing a jammed staple.
The system may be live and the staple could be
forcefully ejected while you are attempting to
unblock the jam.
■ Never use this staple gun for fastening electri-
cal cables.
It is not suitable for the installation
of electrical lines, can damage the insulation
of electrical cables and thus cause electrical
shocks and increase the risk of fire.
WARNING!
■ To avoid risks, damaged mains cables of
the appliance should be replaced by the
manufacturer or the manufacturer’s customer
service department or a similarly qualified
person.
Before use
NOTE
► Only fill the magazine when the appliance is
switched off! Set the ON/OFF switch to
the position "0" and pull out the plug!
Filling the magazine
♦ Squeeze the magazine slider (see fig. A).
♦ Pull the magazine slider out of the
magazine of the appliance (see fig. B).
♦ Fill the magazine with staples or nails
(see fig. C).
♦ After filling, push the magazine slider back
into the magazine as far as the stop and you
hear and feel it click into place.
NOTE
► When filling with nails, use the right shaft
(as shown in fig. C). Ensure that the nail
heads are always at the top.
► Note the maximum fill level of approx.
85 staples or approx. 75 nails.
► If the red line on the front of the magazine
slider
4a
coincides with the marking of the
fill level indicator
8a
, then the magazine is
empty.
Setting the impact force
NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Impact force control
Increasing the impact force
♦ Turn the impact force control anticlockwise.
Reducing the impact force
♦ Turn the impact force control clockwise.