Parkside 324133 1904, Оригинальное руководство пользователя

Страница: 9 / 38

PFS 400 A1 ■ 6 │
GB
│
IE
│
NI
│
CY
NOTE
► Do not exceed the maximal viscosity of the
appliance . The spray material must not be
too thick . Otherwise, the appliance might
clog .
► Ensure that the spray material and thinning
agent are compatible . Using an unsuitable
thinning agent may cause clots that clog the
appliance . Never mix synthetic resin varnish-
es with cellulose thinners .
► To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material .
► Granular products and products containing
solids must not be sprayed . Their abrasive
effect will shorten the service life of the pump
and valve .
Preparing the surface
♦ Carefully cover a large area around the spray
surface . Any surface that is not masked could
become contaminated .
♦ Ensure that the surface is clean, dry and free of
grease .
♦ Polished surfaces should be lightly sanded and
the sanding dust removed .
Setting up
Assembly/disassembly
♦ Move the ▸ mark on the spray unit to the
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the mark on the motor unit
♦ Unlock the lock
5a
. Turn the ▸ mark on the
spray unit to the mark on the motor unit
to separate the two units .
Choosing/changing the nozzle
Nozzle Use
1 .8 mm nozzle
all types of paints and
lacquers
2 .6 mm nozzle
viscous spray material
♦ Undo the union nut completely and remove it
from the spray unit .
♦ Fit the desired nozzle onto the nozzle head .
♦ Screw the union nut back onto the spray
unit .
Adding spray material
♦ Unscrew the paint cup from the spray
unit .
♦ To work on a horizontal object, place the riser
pipe in front, facing the nozzle head . To
work overhead, place the riser pipe in the
back, facing the motor unit .
♦ Fill the paint cup with the spray material and
screw it firmly onto the spray unit .
Switching the appliance on/off
Working methods:
♦ Hold the spray gun at a constant distance
from the object . The ideal spraying distance is
approx . 15 cm .
♦ Work out the best settings by carrying out a test .
♦ Do not switch the appliance on/off over the
spray surface . Rather, start/end the spraying
process approx . 10 cm from the spray surface .