Parkside 322691 1901, Инструкции по эксплуатации и безопасности

Страница: 35 / 132

34 GB/IE
˜
Attaching/removing the
accessory tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use . Always
wear protective gloves when handling
accessory tools!
m
WARNING!
Always switch the product off, remove
the battery pack 10 and let the
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
u
Keep your hands away from the accessory
tool when the product is in operation .
m
CAUTION! RISK OF INJURY!
u
After the product has been switched off,
the accessory tool continues moving for
some time . Do not touch the accessory tool
and do not attempt to brake it .
This product is equipped with an automatic
spindle lock to open or close the chuck 1 with
the chuck sleeve 2 .
¾
Open the chuck 1 : Turn the chuck sleeve
2 in a counter-clockwise direction (Fig . E) .
¾
Insert a suitable accessory tool into the chuck
1 as deep as required .
¾
Close the chuck 1 : Hold the accessory tool
in position . Turn the chuck sleeve 2 in a
clockwise direction .
NOTES
u
This product is equipped with a Röhm drill
chuck with an anti-lock function .
u
If you attempt to open the fully opened
chuck 1 further, the anti-lock function will
be activated to protect the chuck .
u
When the anti-lock function is activated,
the chuck 1 cannot be closed by turning
the chuck sleeve 2 in a clockwise
direction . A ratcheting sound will be
produced when you attempt to close the
chuck .
u
Deactivating the chuck’s 1 anti-lock
function: Turn the chuck sleeve 2 in a
clockwise direction by a certain extent .
Then, turn the chuck sleeve suddenly and
quickly in a counter-clockwise direction .
Repeat this action if the anti-lock function
is still active . When the anti-lock function is
deactivated, you should be able to close
the chuck 1 without ratcheting sounds .
˜
Gear selection
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the gear selector
4 until the product has come to a
standstill .
¾
Change the gear by sliding the gear selector
4 forwards or backwards (fig . F) .
1
st
gear:
Suitable for: Screwing
Speed: Low
Torque: High