Parkside 315259, Перевод оригинальной инструкции

Страница: 13 / 64

13
CY NI IE GB
Only tighten the rotary knob
(11) by hand! The use of maxi-
mum manual force will damage the
tubular shaft.
B
Assembly of the front tubular
shaft (6):
3. Remove the cap (23) on the front tu-
bular shaft (6). Loosen the star wheel
(8/11)). Slide the front tubular shaft
(6) optionally onto the middle tubular
shaft (9) or onto the tubular shaft (12)
on the appliance housing in a slight
rotating movement. The safety button
(7) locks into place. Fix the two tubular
elements in place with the rotary knob
(8/11).
Only tighten the rotary knob
(8/11) by hand! The use of
maximum manual force will dam-
age the tubular shaft.
C
4. Place the round handle (13) onto
the tubular shaft of the device
housing (12). Fold on the counter-
holder (24) of the round handle
and screw it on together with the
large washer (25) and the rotary
knob (26).
The dismantling takes place in reverse
order.
Initial Operation
Do not use the equipment
without the hand guard.
Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment is
functional before each use.
The On/Off switch and the
safety switch must not be
held closed. They must switch
off the motor when on is re-
leased. Should a switch be
damaged, stop working with
the equipment. Ensure that the
mains voltage value matches
the label on the equipment.
Note noise protection and local
specifications. The use of the equip
-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
D
Swivelling Out the
Blade Beam
1. Hold the safety blade beam (
A
1) on
the handle to adjust the blade beam (5).
2. Unlock the safety lever (3) and keep it
pressed.
3. By simultaneously exerting pressure on
the lock lever (4), you will loosen the
fixation of the cutter bar (
A
1).
4. The safety blade beam (
A
1) can now
be swivelled out. Use the stop stages
and allow the stop lever (4) to click
back in. You can choose 9 stop stages.
5. Then, release the safety lever (3) again
and ensure that it latches back into its
initial position.
Attach the shoulder strap
Attach the shoulder strap spring clip
(
A
19) to the carrying eyelet (
A
20) on
the tubular shank of the device. Set the
strap length such that the spring clip on the
shoulder strap is roughly at the height of
your hip.