Parkside 309892, Инструкции по эксплуатации и безопасности

Страница: 17 / 73

17 GB/CY
„ „ Only use filtered, lubricated and regu-
lated compressed air.
z
Adjusting the torque
„ „ Set the torque control
1
to the correct
torque by pressing it toward the housing
and turning it until it locks at the desired
setting.
„ „ Be sure the operating pressure of the
compressor is between 5 and 6.3 bar.
Note: the ideal pressure is 6.3 bar. The
maximum torque cannot be reached at a
pressure of only 5 bar or with insufficient air
flow.
ATTENTION! Car/truck - do not tighten
wheels with the highest torque (F
- strong). If the torque is too high, it may
result in damages.
ATTENTION! The correct torque must
be examined using a torque wrench
once the pneumatic impact wrench has
been used.
Setting
F
R
R open
F
tighten
(low)
F
tighten
(normal)
F
tighten
(high)
z
Initial use
„ „ Activate the trigger 3 to start the equip-
ment.
„ „ Release the trigger 3 to deactivate the
equipment.
z
Changing rotation
ATTENTION! The device must come to
a complete standstill before changing
the direction of rotation.
ATTENTION! A machine rotating in an
unexpected direction can be dangerous.
Always pay attention and use care.
Note: The impact driver clockwise /
counter- clockwise rotation. Use the
rotary switch
1
to change the direction
of the impact driver.
„ „ Turn the rotay switch
1
to the right to-
wards the “F” mark („Forward / Fasten“)
for clockwise operation. You can choose
between three different torques (see
“Set torque”) You can now e.g. tighten
screws.
„ „ Turn the switch to the left towards the “R”
mark (“Reverse/Release”). This setting
changed the direction of rotation. You
can now e.g. loosen screws.
z
Correctly holding the
equipment
This equipment weighs 2.1 kg.
„ „ Hold the equipment with both hands to
ensure safe operation (see Fig. D).
z
After initial use
Once the task has been finished the device
Commissioning / After initial use