Parkside 309892, Инструкции по эксплуатации и безопасности

Страница: 16 / 73

16 GB/CY
„ „
In torque controlled machines
with continuous rotation the air
pressure has a safety-related
impact on the output. There-
fore hose length and diameter
requirements must be deter-
mined.
„ „
Never carry pneumatic tools
by the hose.
z
Commissioning
Note: the device is operational after install-
ing the plug nipple 6 .
z
Connecting
Note: only use connection hoses with a
minimum inside diameter of 9 mm.
„ „ First wrap a piece of Teflon tape (not in-
cluded) around the outer threads of the
plug nipple
6 and the lubricator 10 (see
Figure B).
„ „ Now screw the plug nipple 6 into the
thread of the lubricator 10 (see Figure C).
„ „ You must use an open-end spanner (14
mm / 17 mm) to tighten this connection
with moderate force.
„ „ Now turn the combination of lubricator
10 and plug nipple 6 into the connec-
tion thread
2
of the impact driver (see
Fig. C).
„ „ Also retighten this connection with an
open-end spanner (17 mm).
„ „ Now press the air hose onto the plug nip-
ple
6 using a little force, until the hose
locks in.
ATTENTION! Be sure the air hose is
firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two
screw connections between lubricator
10 , plug nipple 6 and machine are
securely seated.
z
Inserting the socket wrench
or bit
„ „ ATTENTION! Always install the desired
socket key before connecting the tool to
your compressed air system. Always dis-
connect the compressed air supply from
the compressed air connection
2
before
attaching or changing socket keys
8
.
„ „ Insert the correct socket
8
, if necessary
with extension
5
, in the drive 4 .
„ „ Slide the socket attachment 8 onto the
square
4
of the drive.
„ „ Be sure the snap ring is locked into the
notch of the socket attachment
8
.
„ „ Only use socket attachments sizes ½“
specified in figure A.
„ „ Be sure the socket attachments
8
used
are not damaged. Never use damaged
or the wrong size (not suitable) socket
attachments
8
.
z
Adjusting the compressed
air
Note: this device is designed for an operat-
ing pressure of up to 6.3 bar and a com-
pressor with the minimum air flow specified
in the technical specifications. When setting
the air pressure, remember the pressure
drops by approx. 0.6 bar with a hose length
of 10 m and an inside diameter of 9 mm.
Safety instructions for air tools / Commissioning