Parkside 276009, Руководство по эксплуатации

Страница: 13 / 60

PDWS 125 A1 ■ 10 │
GB
│
CY
Attaching the grinding disc
CAUTION!
► Disconnect the compressed air tool from
the compressed air supply before replacing
the accessory tool or accessories, or before
carrying out adjustments or servicing. The
spindle must be at a standstill.
Lock the spindle
♦ Place the rear clamping flange on the spindle
. This is correctly attached if the spindle
cannot be rotated.
♦ Place the open-ended spanner supplied
over the collar of the rear clamping flange to
prevent it from turning.
Attaching the grinding disc
♦ Place the grinding disc on the rear clamping
flange .
The grinding disc must be evenly placed on
the rear clamping flange .
Fixing/loosening the front flange
The 2 sides of the front flange are different.
Screw the front flange onto the spindle as
follows:
For thin grinding discs (see figure 1):
♦ The collar on the front flange faces upwards
so that the thin grinding disc can be safely
clamped.
12
≤ 3,2 mm
fig. 1
For thick grinding discs (see figure 2):
> 3,2 mm
fig. 2
The collar on the front flange faces downwards
so that the front flange can be safely attached
to the spindle .
♦ Locking the spindle .
♦ Tighten the front flange in a clockwise direc-
tion using the two-hole spanner .
Loosening the front flange:
♦ Lock the spindle .
♦ Undo the front flange in an anticlockwise
direction using the two-hole spanner .
Fitting the connector nipple
♦ Remove the plastic protective cap from the
appliance‘s air inlet.
♦ Wrap the threads on the connector nipple
with the teflon tape supplied.
♦ Screw the connector nipple into the air inlet.