Parkside 276009, Руководство по эксплуатации

Страница: 12 / 60

PDWS 125 A1
GB
│
CY
│ 9 ■
If this happens, an uncontrolled compressed
air tool turns rapidly against the direction of
rotation of the accessory tool caught in the
blockage.
■ If, for example, a grinding disc catches or jams
in a workpiece, the edge of the grinding disc
that is projecting into the workpiece can get
caught and break off the grinding disc or cause
a kickback. The grinding disc can then fly in
the direction of the operator or away from him,
depending on the direction of rotation of the
disc at the blockage.
This can also break grinding discs.
■ A kickback is caused by incorrect use or misuse
of the compressed air tool. This can be avoided
by taking proper precautions as given below.
a) Hold the compressed air tool firmly
in both hands and position your body and
arms so they can absorb the force of a
kickback. Always use the auxiliary handle,
if available, so you have maximum control
over the kickback force or reaction torques
at full speed. By taking adequate precau-
tions, the operator can stay in control of the
kickback and reaction torques.
b) Never hold your hand close to rotat-
ing accessory tools. The accessory tool
could move across your hand in the event
of a kickback.
c) Keep all parts of your body outside
the region in which the compressed air tool
is likely to move in event of a kickback. The
kickback will force the compressed air tool
in the opposite direction to the direction of
rotation of the grinding disc at the block-
age.
d) Take special care when working
around corners, sharp edges, etc. Avoid
allowing the accessory tool to bounce back
from the workpiece, or jam. The rotating ac-
cessory tool is more likely to jam in corners
or sharp edges or if it bounces. This can
cause a loss of control or kickback.
e) Do not use chains or toothed saw
blades. Such accessories often cause a kick-
back or loss of control over the power tool.
Operation
NOTE
► Screw the plug nipple on before first use.
Attaching the auxiliary handle
CAUTION!
► Do not work with the tool if the auxiliary
handle is not attached!
♦ Screw the auxiliary handle firmly onto the
left-hand or right-hand side of the machine.
Attaching the protective cover
CAUTION!
► For safety reasons, always use the protective
cover !
■ The protective cover is mounted on delivery
with 2 screws on the device.
♦ For rotation of the protective cover , you first
remove all screws with the hex key .
♦ Replace the protective cover at most by a
hole added to the new position.
The closed side of the protective cover must
always be facing to the operator.
✓ ✗
♦ Attach the protective cover with 3 screws on
the device.
Screw the remaining screw into the threaded
hole.
♦ Check for secure seating: The protective cover
must be securely attached.
Only use accessory tools
which the protective
cover protrudes be-
yond by at least 2 mm.
WARNING!
► The supplied protective cover is for grinding
disc use only.