Parkside Performance 289752, Инструкции по эксплуатации и безопасности

Страница: 15 / 49

Q
Maintenance
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see “Technical data”).
Q
Repair
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
Q
Storage
o
Switch the product off and remove the battery
pack
4
.
o
Clean the product as described above.
o
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place.
o
Always store the product in a place that is
inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
o
We recommend using the original package for
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
o
Regularly check the charge level of the
battery pack, if it is to be stored for an
extended period. Optimum storage conditions
are cool and dry.
o
Grinding discs must be dry and stored
upright, and should never be stacked.
Q
Transportation
o
Switch the product off and remove the battery
pack
4
.
o
Attach transportation guards, if applicable.
o
Always carry the product by its handles.
o
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
o
Secure the product to prevent it from slipping
or falling over.
Q
Troubleshooting
WARNING!
u
Only perform the steps described within
these instructions! All further inspection,
maintenance and repair work must be
performed by an authorised service centre or
a similarly qualified specialist if you cannot
solve the problem yourself!
Suspected malfunctions are often due to causes
that the users can fix themselves. Therefore check
the product using this section. In most cases the
problem can be solved quickly.
Problem Possible
cause
Solution
Product does
not start
Battery pack
not properly
attached
Attach properly
Battery pack
discharged
Remove and
charge battery
pack
Battery pack
damaged
Check by
a specialist
electrician
Other electrical
defect to the
product
Check by
a specialist
electrician
Product does
not reach full
power
Air vents are
blocked
Clean the air
vents
Unsatisfactory
result
Accessory is
worn
Replace with a
new one
Accessory
not suitable
for intended
operation
Use suitable
accessory
Product
suddenly
stops
Product
overloaded
Remove the
product from
the workpiece
and switch it on
again
Battery pack
discharged
Remove and
charge battery
pack
Battery pack
too hot
Remove battery
pack and let it
cool down
Excessive
vibration or
noise
Accessory is
dull/damaged
Replace with a
new one
Bolts/nuts are
loose
Tighten bolts/
nuts
Guard cannot
be adjusted
Debris Clean the
product and
lubricate the
guard base if
necessary
17 GB