Hose Products Division
Parker Hannifin Corporation
Wickliffe, Ohio
www.parkerhose.com
6
Crimping Machine
TH8-D206
Bulletin 4480-T22-US
CRIMPING WITH SMALL DIE SERIES
Place the cone insert squarely in
the base of the crimper.
Place the die set and hose and
fitting loosely in the cone insert.
Use care to be certain that the
die halves do not overlap.
Place the Pusher Plate on top
of the die set.
Slide the Pusher onto the stud on the
hydraulic ram and press and hold the
start switch until the motor shuts off.
Check the finished crimp diameter to
be certain that it is within the crimp
specification limits.
Lubricate die fingers, all contact
surfaces and die cones.
WARNING: Failure to lubricate
will cause damage to die sets and
crimper.
Correct alignment of the hose
and fitting in the die set is shown.
Reference crimp specifications
for fitting locations
Mark insertion depth on hose
and push all the way into fitting.
Reference crimp specifications
for insertion depths.
Small Die Crimping
