Parker SDC, Руководство пользователя

Страница: 21 / 28

Shaker Dust Collector SDC Series
17
5.2 Dust Removal
As the SDC system cleans, dust collects in the drum. The dust should be removed periodically
to prevent re-entrainment, eliminating dust piling up into the hopper section. Your application will
determine the appropriate intervals between emptying the drums.
To remove the drum barrel, disengage the drum clamp and lift up the drum lid.
Reverse these directions to replace the drum barrel.
5.3 Servicing the Shaker Mechanism
On a quarterly basis, remove the shaker mechanism cover plate and inspect the moving parts of the
shaker mechanism. Refer to Figure 13, Detail A.
Check that all hardware is tight, including the set-screws attaching the hub to the motor shaft, the
shoulder bolt that is threaded into the hub and the nuts that secure the drive shaft to the shaker fingers.
If hardware requires tightening, use a thread locker to secure. Inspect all bushings for signs of wear.
Also inspect the rubber grommet that seals the mechanism to the cabinet for tears or excessive wear.
If it is not time to replace the bags, inspect them for wear or abrasion around the shaker fingers.
It is recommended that you grease shaker motor every 3,600 hours with high grade gall bearing grease
(i.e. Shell Dolium or Chevron SRI-2).
FIGURE 11
FILTER REPLACEMENT
61-10074-11
FILTER INSERT
FILTER CASSETTE
FILTER BAG
ASSEMBLY
FILTER SNAP
BAND
Figure 12. Filter Replacement