Parker SDC, Руководство пользователя

Страница: 11 / 28

Shaker Dust Collector SDC Series
7
3.2.2 Single Module Hopper Assembly
Assemble the four leg weldments to the hopper with the shown hardware (refer to Figure 5; Detail A)
and making sure the base pads are oriented as illustrated. Secure hopper/leg assembly to concrete
mounting pad with appropriate mounting hardware. Anchors should be provided by customer or
contractor according to local codes.
3.2.3 Multiple Module Hopper Assembly
Position multiple hoppers side by side and bolt through corner gussets as illustrated in Figure 6,
Section A-A on page 7. Locate and attach the leg weldments to the hopper assembly per Figure
6, Detail A. Locate the diagonal support braces and attach it to the hopper corner brackets on left,
right and rear sides of hopper referencing Figure 6, Detail B making sure the base pads are oriented
as illustrated in Figure 6. Secure hopper/leg assemblies to concrete mounting pad with appropriate
mounting hardware. Anchors should be provided by customer or contractor according to local codes.
Secure hopper/leg assemblies to concrete mounting pad with appropriate mounting hardware.
Anchors should be provided by customer or contractor according to local codes.
Base pads are to be oriented as illustrated in Figure 5 & 6.
TIP OVER HAZARD
The SDC dust collector should be mounted on a solid, level, reinforced concrete foundation.
Other mounting options are also possible. Each standard SDC unit has been designed to meet
Seismic Zone 4 and 100 MPH wind loading conditions. Structural calculations for the foundation or
other mounting arrangements must include the weight of the collected material and the weight of all
auxiliary equipment installed with the dust collector (ducting, silencers, afterfilter assemblies, etc.).
Consult a professional engineer when designing the foundation for the unit.
Interconnecting ducting should be properly sized to meet the recommended air velocities for the
material being collected. Follow ducting design methods as listed in the Industrial Ventilation Manual,
as recommended by the American Conference of Governmental Industrial Hygienists.
3.2 Standard Equipment Assembly
CRUSH AND ELECTROCUTION HAZARD
Use adequate safety measures when lifting and assembling any heavy components.
Consult your local plant safety personnel for recommendations.
In preparing to attach the filter module to the hopper, connect lifting slings and spreader bars to all
filter module lifting points with clevis pins. Use spreader bars to distribute the load evenly.
Location must be clear of all obstructions, such as utility lines or roof overhangs.
Remove all crating, strapping and hold-down bolts. Locate all hardware bags, sealant and other
assembly materials provided with your unit.
3.2.1 Hopper Assembly
The SDC unit is designed to mount directly on top of the hopper assembly. The hopper assembly
consists of a hopper bin, legs, sway-bracing (on larger models), optional flex duct, hose clamps, 20 or
55-gallon drum, drum lid and drum clamp. A hardware kit is also included to bolt the filter module to
the hopper.