Parker PV0110BSPH, Операционное обслуживание комплектующих и уход

Страница: 9 / 26

9
ASSEMBLY INSTRUCTIONS
TO ASSEMBLE UPPER HANDLE
NOTE: See Upper Handle Assembly Page 12 of this owner’s guide for reference numbers used in these instructions.
Insert upper handle into lower struts and install 4 bolts (10) Washers (11) Nuts (12). Once bolts are installed they can be
tightened.
Place controller assembly onto upper handle and insert 2 bolts and secure (Refer to upper handle assembly page 12.)
Use Bolt (4) and (8) with nut (5) and washer (6).
Install throttle cable (15) to upper handle using 2 bolts (16) and 2 Nuts (17) and tighten.
TO ASSEMBLE SPIN-PAK
NOTE: See Housing Assembly Page 17 of this owner's guide for reference to numbers used in the following
instructions.
1. Remove hex head bolts (39), flat washers (30), and lock nuts (27) from the three upper holes used to secure
retaining ring (58) to housing assembly (24). DO NOT remove the bottom bolt or retaining ring from housing
assembly.
2. Align the holes in Spin-Pak (59) with three upper holes in retaining ring and housing assembly.
3. Replace hardware removed in Step
1
and tighten.
ATTACHING INTAKE HOUSING
1.
Insert hinge bosses on collar of intake housing (61) behind the hinged extension on front cover assembly (16).
2.
Swing intake housing (61) to lay flat against front cover assembly (16).
3.
Secure by placing f1atwasher (31) and adjusting knob (53), on pivot bolt, over the collar of intake housing and
tighten adjusting knob.
ATTACHING DUST BAG
1. Place large loop in upper bag straps over the upper handles.
2. Place neck of dust bag over Spin-Pak until tie strap can be pulled tight around neck of housing, just over bead on
retaining ring. Bead must be covered.
3. Place bag hooks onto loops in lower bag straps and hook to lower crossbar.
WARNING:
Failure to attach bag hooks to lower crossbar can cause premature wear of bag and neck at the Spin-Pak.
The Spin-Pak may also break prematurely due to excessive weight from the bag.
WARNING: The engine contains NO OIL . Read the Engine Instruction Manual carefully before operating the VAC 35.
Be sure you know how to start and stop the engine before proceeding further. Do not start the engine until all assembly
is finished.
WARNING:
Make a thorough inspection to see that all fastenings are tight and all parts are properly installed. DO NOT
start engine without intake housing and dust bag in place. If engine is started without intake housing attached, serious
injury may result by drawing clothing or parts of the body into the fan. If engine is run without Spin-Pak or dust bag,
small stones or other objects may be picked up and propelled at operator or bystanders through the unprotected
opening causing serious injury.