Chapter 2: Installing the PowerStation
Installing the PA2 PowerStation
PA2 PowerStation User Guide
2-7
Installing the PA2 PowerStation
Once you have prepared the location for your PowerStation, you are ready
to install the unit. To do so, you need to mount the PowerStation to your
enclosure using screws and metal clamps in what is called a bracket
assembly. The bracket assembly contains a mounting clamp with “feet”, a
screw, and for 15” units, a nut as shown in figure 2-1.
The mounting clamps secure to the PowerStation using a sliding
mechanism. You must slide the feet of the mounting clamp into the
appropriate slot on the PowerStation.
For your convenience, all necessary mounting hardware is included with
the unit.
Figure 2-1 and 2-2 display the bracket assembly and mounting clamp.
Some units mount with a T-style clamp.
Figure 2-1: Bracket Assembly
Figure 2-2: Mounting Clamp
To mount the PowerStation properly, refer to the chart on the next page
that corresponds with the display size you are using. General mounting
steps are listed below the chart.
Nut only for 15” units
Mounting Clamp
Feet
