14
Parker Hannifin Corporation
|
Pump & Motor Division
|
Kings Mountain, NC
WARNING:
This product can expose you to chemicals including lead or DEHP which are known to the state of California to cause cancer,
birth defects, and other reproductive harm. www.p65warnings.ca.gov
Assembly Instructions
6)
Mount shaft end cover facing down in a vise and
examine checks and/or plug (
Fig. 9
). Make sure checks
and/or plug are tightly in place. They might still be inside
the shaft end cover from disassembly. Replacement
is necessary only if parts are damaged. Remove with
screwdriver.
Figure 9
7)
Verify dowel pins are in place in any new castings (
Fig. 10
).
Examine all of the dowels. Before inserting, make certain
that the hole is clean and free from burrs. Gently start the
pin straight into the hole and tap lightly with a soft-faced
hammer.
Figure 10
8)
Re-affix or replace section seal (
Fig. 11
). Verify both
sides of the section seal are free of debris. If replacing
section seal, grease the new seal then insert firmly into the
grooves on both sides of the gear housing.
Figure 11
9)
Place gear housing over shaft end cover and dowels,
lining up witness marks (
Fig. 12
).
Tap it with a soft hammer until it rests tightly against the
shaft end cover. Be careful not to pinch the gasket seal.
Also be sure that the large rounded core is on the inlet
side.
Figure 12
