Parker OSPP-Classic, Руководство по эксплуатации, Страница: 15 / 32

15
EN
11 Service / Maintenance OSPP-Classic / -KF
Attention
Maintenance and repair work must only be carried out by specially trained and instructed personnel!
The machine or the working zone must be cordoned off for safety purposes as required!
Danger of crushing
Carry out maintenance work only with the machine switched off and the compressed air system
depressurized.
Preparations and Things Needed
Have the following things ready:
• Seal kit or service kit.
• Screwdrivers of various sizes.
• Allan keys of various sizes.
• Dismantle the required parts in order to be able to freely move the piston / guide carriage. If necessary,
completely remove the linear drive.
• Switch off the main switch and secure it against unintentional switching-on.
11.1 Maintenance intervals
Km operated Maintenance
Instructions
From 8000
OSPP-Classic
Dismantle cylinder completely if necessary,
clean parts and replace worn parts
Chapter 11.3, page 16
When necessary Clean inner sealing band.
Depending on load and
working time
OSPP-Classic-KF
If required, completely dismantle and clean the
guide carriage and replace wearing parts.
Re-lubricate the roller carriage.
Chapter 11.4, page 21
Also observe the operating instructions of the entire plant!
Attention, Ø16, 25 and 32:
After loosening the screws of the end cap mounting, screws of the end cap (pos.36) must be checked upon
their correct torque (see table page 18) , before pressure is applied.
Pos. 36
Screw for end cap
Torque moments
table page 18
Screws of the end cap mounting