Parker AC30V Series, Техническое руководство

Страница: 15 / 30

Fan Control Application Manual
13
AC30V series Variable Speed Drive
ID Trip Name Disabled in Partial mode Disabled in Full mode Drive Protection
1 OVER VOLTAGE

2 UNDER VOLTAGE
(1)
Note 1 Note 1
3 OVER CURRENT

4 STACK FAULT

5 STACK OVER CURRENT

6 CURRENT LIMIT
 
7 MOTOR STALL
 
8 INVERSE TIME
 
9 MOTOR I2T
 
10 LOW SPEED I
 
11 HEATSINK OVERTEMP
 
12 AMBIENT OVERTEMP
 
13 MOTOR OVERTEMP
 
14 EXTERNAL TRIP
 
15 BRAKE SHORT CCT
 
16 BRAKE RESISTOR
 
17 BRAKE SWITCH
 
18 LOCAL CONTROL
 
19 COMMS BREAK
 
20 LINE CONTACTOR
 
21 PHASE FAIL
 
22 VDC RIPPLE
 
23 BASE MODBUS BREAK
 
24 24V OVERLOAD
 
25 PMAC SPEED ERROR
 
26 OVERSPEED
 
27 SAFE TORQUE OFF
Note 1. The Under Voltage trip is enabled when Fire Mode is active, but the trip level is reduced by 50%.
If a trip source becomes active when the associated trip is disabled the drive will continue to run. This is also the normal behavior of the drive,
(when Fire Mode is not active). If the associated trip is designed for drive protection, this will be recorded in non-volatile memory. The recorded
values are available to view in the Drives’ Trips History.
When Fire Mode is activated and a trip source becomes active and the associated trip is enabled, the Drive will trip, causing the motor to stop.
This is similar to the normal behavior of the Drive, (when Fire Mode is not active). However, when Fire Mode is active the firmware within the
Drive continues to monitor the trip source, once the trip source has become inactive the drive automatically resets the trip condition and restarts
the drive.
www.comoso.com