Parker 947103-169cc, Руководство владельца/оператора

Страница: 7 / 22

GB - 7
Replace gasoline tank cap securely and
clean any spilled fuel before starting engine.
If fuel is spilled on clothing, change clothing
immediately.
Properly remove fuel before tipping unit.
NEVER store fuel inside where there is an
open flame, such as a water heater.
ALWAYS drain fuel outdoors away from
ignition sources.
Never pick up or carry equipment while the
engine is running.
ALWAYS shut off engine and close fuel
shutoff valve when transporting unit on a
truck or trailer.
Use at least two people when loading or
unloading machine.
DO NOT drop machine when loading or
unloading or damage to rear axle may occur.
The blower covered in this owner's guide is
shipped complete in one box. Follow all
instructions on assembly very carefully.
Carton Contents
Unit
Literature Pack
ASSEMBLY
1. Remove all items from carton.
2. Position blower on its wheels and chock
wheels to keep unit stable.
NOTE: DO NOT discard the carton or any of
the inserts until the unit is completely
assembled.
3. Remove four 5/16" hex bolts (item 4),
four 5/16" locking hex nuts (item 2) and
handlebar brackets (item 5) that are
loosely assembled on the handlebar
supports.
Handle Assembly
(Figure 3)
1. Mount handlebar (item 1) to the
handlebar supports (item 3) using four
5/16" hex bolts, four 5/16" locking hex
nuts and two handlebar brackets.
2. Torque fasteners to 17 lbf-ft (1.9 N•m).
Do not overtighten.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Figure 3
1
1. Handlebar
2. 5/16" Locking Hex Nut
3. Handlebar Support
4. 5/16" Hex Bolt
5. Handlebar Bracket
2
3
4
5