English
1-4
Reference and Sequencing
If using three wire control
Start button (n.o.) between 6,7
Stop button (n.c.) between 6,10
Speed potentiometer: 1 (Low), 4 (High),
2 (Wiper) OR
External speed reference: 1(-) and 2(+)
Start contact between 6 and 7
Jog contact between 6 and 9
Reverse Direction contact between 6 and 8
Calibration
POWER ON
All calibration is done in software, through the keypad.
SETUP PARAMETERS
P1 Application Select Select the application macro
P2 Max Speed Set max speed in Hz
P3 Min Speed Set min speed in %
P4 Acceleration time Accel time to Max Speed in sec
P5 Deceleration time Decel time from Max Speed in sec
P6 Motor Current Motor full load current in amps
P7 Base Frequency Motor nameplate frequency in Hz
P8 Jog Setpoint Set jog speed in % of max speed
P9 Stop Mode 0=Ramp; 1=Coast; 2=Injection braking
P11 V/Hz shape 0=Linear; 1=Quadratic (fan or square)
P12 Overload Rating 0=150% for 30s.; 1=110% for 10s.
P13 Fixed Boost Set boost in % volts (V/Hz mode only)
P99 Password Set from 0001 to FFFF for protection
DIAGNOSTICS
d1 Frequency Output frequency (Hz)
d2 Speed Setpoint Speed SP (% of Max Speed)
d3 DC Link Volts Voltage of DC Bus
d4 Motor Current Motor Current (amps)
Power-up
screen
SAVING
Changes
take effect
as soon as
they are
entered and
parameters
are saved
automatically
in a few
seconds
The drive powers up in
LOCAL MODE.
Use the green/
red buttons to start/stop and the up/down arrows to adjust
speed. To switch to
REMOTE MODE,
hold the STOP
button down until
L0C
disappears. To revert to
LOCAL
MODE:
At the
rdy
screen, push STOP until
L0C
appears.
Cloning
The 650X drives may be cloned using the 6514 Clone
option that plugs into the keypad slot. Settings include
to/from, I/O configuration and full/part transfer.
Serial Comms
The 6513 Serial Communication option can be
plugged into the keypad slot. It can be used to exchange information between the Master and Slave drives in
RS485/232 format, up to 32 units can be connected together. Front panel LED indicators provide status and
health indication.
650V & 650G only
650V & 650G only
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - [email protected]