401/402XR Series Product Manual
Chapter 1 - Introduction
6
www.parkermotion.com
Parker Hannifin Corporation
1140 Sandy Hill Road
Irwin, PA 15642
Return Information
Returns
All returns must reference a “
R
eturn
M
aterial
A
uthorization”,
(RMA)
, number. Please call your local
authorized distributor or Parker Hannifin Corporation Customer Service Department at 800-245-6903
to obtain a “RMA” number. See Parker Hannifin Corporation Catalog #8080/USA, page D34, for
additional information on returns and warranty.
Repair Information
Out-of-Warranty Repair
Our Customer Service Department repairs Out-of-Warranty products. All returns must reference a
“RMA” number. Please call your local authorized distributor or Parker Hannifin Corporation Customer
Service Department at 800-245-
6903 to obtain a “RMA” number. You will be notified of any cost prior
to making the repair.
Warnings and Precautions
Vertical Operation
Depending upon your load and ballscrew selection the carriage and load may ‘backdrive’ in power loss
situations potentially causing product damage or personal injury.
Strain Relieve Electrical Components
All electrical components (such as brakes, encoders, and limit/home switches) must be strain relieved.
Failure to strain relieve electrical wires or cables may result in component failure and/or possible
personal injury.
Pinch points
Product does have pinch areas where moving elements relative to each other come together- Take
precaution
Unexpected Motion
Product can begin motion without warning due to an electrical or controller failure.
Specification Conditions and Conversions
Specifications are Temperature Dependent
Catalog Specifications are obtained and measured at 20 Degrees C. Specifications at any other
temperature may
deviate
from catalog specifications. Minimum to Maximum continuous operating
temperature range
(with NO guarantee of any specification except motion) of a standard unit before
failure is 5 - 70 Degrees C. Certain components can be eliminated or substituted to improve
operation at these temperatures. Positioners with low temperature or high temperature components
will be handled as specials, contact your local distributor.
Specifications are Mounting Surface Dependent
Catalog Specifications are obtained and measured when the positioner is
fully supported
,
bolted
down
(to eliminate any extrusion deviation), and is mounted to a work surface that has a
maximum
flatness error
of
0.013mm/300mm (0.0005”/ft).