22
23
ASSEMBLY
ASSEMBLY
1
ATTACH FRONT, REAR & SIDE LEG BRACES
The front and rear side braces are longer and are stamped with letter B. Fit both into place. The side braces are
shorter and are stamped with letter C. Fit both into pace.
NOTE:
The leg Braces should be positioned to the inside of the the Legs.
NOTE:
Insert the hex head screws from the outside with the flange nut positioned to the inside
i
Identify the highlighted pre-drilled holes.
Use hex head screws and flange nuts to fit
the table extension. Pay paticular attention
to the holes used to attach the extension as
if postioned inccorectly the next step will not
be possible.
Using a hex head screw fix the support struts
in place, tightening at the machine side by
hand.
Align the screw holes on the table
extensions with those on the table.
1
ATTACH TABLE EXTENSION
2
BOLT ON TABLE EXTENSION
3
EXTENSION SUPPORT BAR
NOTE:
The pressed steel table extension panels are universal and can fit on either side of the machine.
NOTE:
Do not fully tighten the bolts fully at this stage of the assembly.
i
i
NOTE:
Do not fully tighten the bolts fully at this stage of the assembly.