Model V10 Service
Bulletin HY14-2701-M1/US
- TORO Specific
Revision: 01-01-2005
12
5
-Position Float
Spool
Positioner
15
Torque To:
5 - 6 Ft Lbs
[7 - 8 Nm]
14
13
5
7
9
6
4
1
2
11
12
8
Torque To:
4 - 5 Ft Lbs
[6 - 7 Nm]
Note: This Float Positioner may only be used with the 24990
Work Section Housings having this machined groove
on the end to accept the detent sleeve (Ref. No. 8).
3
10
Apply NLGI #2 Heavy Duty General
Purpose Grease to Surfaces of Ref.
No's. 4, 5, 6 & 8. Insert Spring and
Large Detent Ball (Ref. No's. 5 and 6)
into spool first. Compress spring
when inserting the Small
Detent Balls (Ref No. 4).
Figure
8
. 4-Position Float Spool Positioner
Note: Float Positioner Kit Is For Servicing The Newer Float Spool Design In The 24990 Housing With
The Machined Positioner Sleeve Groove Shown In The Above Drawing.
Ref No.
Description
Quantity
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Float Positioner Kit for 24990 Housings with Groove, Complete
Spool Sleeve
O-Ring Seal
Back-Up Ring
.250 Diameter Detent Ball
Detent Spring
.312 Diameter Detent Ball
O-Ring Seal
Float Detent Sleeve
Inner Spring Collar
Spring
Outer Spring Collar
Positioner Spud
Bonnet Spacer
Bonnet
Bonnet Screw #10-24 X 1.75
1
1
1
4
1
1
1
1
1
1
1
1
1
1
4
Buna-N seals are standard for all
Parker
valve assemblies.
Unless otherwise specified, mount bonnet with drain slot down toward valve mounting feet.
This Float Positioner may only be used with the 24990 Work Section Housings having this machined groove on the end to
accept the detent sleeve (Ref. No. 8).
Apply NLGI #2 Heavy Duty General Purpose Grease to surface prior to installation.
