Park & Garden LS400M-F, Руководство пользователя

Страница: 41 / 48

41
English
OPERATION
Before starting work, check to see that the following are in proper working order:
• Saw blade (firmly mounted? Undamaged? Sharp? Sufficient distance to other parts?)
• Blade guard (undamaged? Distance to saw blade sufficient?)
• Working table (must automatically return to the starting position)
• Power cable, power cable plug and switch (if damaged, have replaced to a qualified electrician)
• Motor brake (after switching OFF maximum 10 seconds post-running of saw blade)
CUTTING
1. Start machine and let the motor reach full speed.
2. Place a log on the working table and lift security handle
3. To make the cut, push the working table with both hands at the handle towards the saw blade
a. Exert only so much pressure that the motor speed does not fall off..
b. Push feed working table until it hits the stop
4. Return working table completely to the starting position.
5. Remove the cut off piece from the feed rock – make next cut
6. If no further cutting is to be done immediately afterwards, turn machine OFF
NOTE! If the log was not completely separated, turn it over and repeat the cutting operation from the opposite side
(reversing cut).
CARE AND MAINTANCE
WARNING!
Switch machine OFF. Wait for saw blade to complete stop. Unplug power cable.
1. Check that all safety devices are operational again after each service
2. Replace damaged parts, especially safety devices, only with genuine replacement parts since parts not tested and
approved by the equipment manufacturer can cause unforeseeable damage
3. Repair and maintenance work other than described in this section should only be carried out by qualified specialists.