SafeAir™ M-600 Installation Guide
24
www.parazero.com
SafeAir M-600 V2 model
Before Landing
When approaching landing, at approximately three to five meters from the take-off
altitude, the parachute system automatically disarms. At that point, a long double-
beep is heard and the LED is
PURPLE
.
If the landing point is at a different altitude than the take-off altitude, or the system
did not disarm for some reason in the air, which may occur when there is a sudden
change in atmospheric pressure, land the drone slowly while keeping it level. After
three seconds, the system disarms itself.
Caution
Failure to disarm the system before landing
will initiate parachute deployment, once power is cutoff
If the system isn’t disarmed, follow manual disarm:
Disarm the system by
flipping the Arm\Disarm switch upwards. Verify that the LED
turns
PURPLE
,
and that you hear a double-beep. Now the system is disarmed.
Wait 3
seconds, then turn the switch down again. The LED will change to
BLUE
.
After Landing
1
First put the safety pin inside the canister
.
2
After the pin is secure, place the safety cover over the parachute system
.
Caution
It is advisable to insert the safety pin back, before turning the drone’s
power off. This will prevent unintentional parachute deployment
