Parasound Ztuner, Руководство пользователя

Страница: 8 / 16

REAR PANEL CONNECTIONS AND CONTROLS continued
12V Trigger Loop Jack
The 12V Trigger Loop jack lets you “daisy-chain” the incoming trigger voltage to an additional
Ztuner or other component.
Note : The total load on your preamp or controller’s trigger output is the sum of the current
drawn by the trigger circuits of each of the components you’ve linked together.
RS-232 Control Jack
This is a DB9 serial port which accepts commands from your system controller and feeds back
status to be displayed. The following can be controlled and displayed:
- Power on
- Station preset number
- Tuned station frequency
- Tuning mode, preset-seek-manual
- FM or AM band
- Stereo, mono, enforced mono
- The Zone number of the incoming control signal
RS-232 codes for the Ztuner are available at our website, www.parasound.com.
Region Switch
Set this switch for the region where you live. Tuning increments in the USA position (North
America) are 200 kHz for FM and 10 kHz for AM. Tuning increments in the EU position (Europe,
UK, Scandinavia) are 50 kHz for FM and 9 kHz for AM.
Zone 1 2 3 4 Switch
You can select different remote command codes to control up to four Ztuners independently
with the same wireless remote control system. Set the Zone switch to the number 1-4 that cor-
responds to the zone you programmed with the remote control handset (see Remote Control).
When you turn on the Ztuner after you move the Zone switch the display will briefly flash ZONE
CHANGE with the zone number you just selected.
Notes :
- The factory settings for the Zone switch and remote handset are 1.
- The Zone switch should only be changed when the Ztuner is turned off.
AC Line Cord
The AC cord supplied with your Ztuner should be connected directly to an un-switched AC wall
outlet or power strip that is always “live.” Connect the AC cord only after you have connected
the antenna wires and audio cables.
AC Voltage Selector On Bo
In
Out
With
C.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.
Auto On
Man Auto
Zone
1 2 3 4
Region
US EU
12V Trigger
RS-232 Control Ext Remote
In Loop
8