Parasound HALO JC 1+, Руководство пользователя

Страница: 8 / 24

8
Rack Mounting Your Parasound JC 1+
To mount the JC 1+ into a 19" wide equipment rack, you must first attach its two “L” shaped rack mount
brackets (included). With its four feet removed, the JC 1+ chassis and front panel height occupies four rack
spaces (7" or 178 mm). You will also need to allow an additional 1 8" (3.2mm) or more below the JC 1+ to
allow for its bottom chassis screws when mounting other components below the JC 1+. Since the JC 1+
operates very warm, when rack mounting you must provide forced air cooling or set the Bias switch to low.
To attach the rack mount brackets:
• Remove the three bolts from each side of the JC 1+. These bolts are arranged vertically, behind its front
panel and in front of its first heatsink fin.
• Line up the three holes on each bracket with the three holes on the JC 1+ and reinsert the bolts.
• Make sure the bolts are tight because they will support the entire weight of the JC 1+ in the equipment rack.
To secure the brackets to the rails of your equipment rack:
• Tighten each bolt just enough to keep the amplifier secure in the rack. This will avoid deforming the
insulating shoulder washers. Eliminating metal-to-metal contact reduces the likelihood of creating a
ground loop that might introduce hum into your system. Please call your Parasound dealer or Parasound
Technical Service if you need additional advice about rack mounting the JC 1+.