Discrete IR Codes for Second Zone
Applies only to remotes that have been re-programmed with Discrete IR Zone Code software.
Note:
The following instructions do not apply to remote handsets that have not been
re-programmed with Discrete IR Zone Codes. An unmodified remote will control the
second zone the same way it did before the PLIIx/Lipsync software upgrade was
installed into the actual C 1 or C 2 controller.
What’s New
The C 1 or C 2 second Zone will now be set up as if it was a sep-
arate device that can be selected on the
MAIN MENU
page. This
allows for discrete one button selection of second zone functions
at any time; it is different than the previous second zone function
described in the C 1 or C 2 Owner’s Guide.
First press the
MAIN button
;
ZONE
will appear in the device
display, along with
C 1/C 2, T3
and the names of seven other
devices (which you can re-name and re-program for the compo-
nents you actually have in your theater).
Press the
ZONE device key
next, after which you must press
the
ON button
. This will activate the Zone function and will also
turn on the C 1 or C 2, but for its remote zone only. You will see
the page with the names of the ten source inputs that can be
selected for the second Zone.
When you are on the
ZONE page
, with the zone function on, the
remote handset’s
VOL+
and
VOL– buttons
,
MUTE button
and
Source keys
control these functions only in the second Zone,
without affecting the C 1 or C 2 main zone operation. If you press
the
OFF button
while
ZONE
is displayed, it will turn off the zone
function and turn off the C 1 or C 2 power if only the remote
zone was in use. It will not turn the off the C 1 or C 2 power if it
is playing in the main zone.
NEW CONTROLS continued
13
