Parasound HALO C-2, Руководство пользователя, Страница: 38 / 68

Unbalanced Lines,” page 58. Balanced and unbalanced input signals normally appear at both the bal-
anced and unbalanced outputs (including the recording outputs). However, in Bypass mode (see the
chapter on “Adjustments, Menus, and Setup,” page 34), when the balanced input is selected its signal
passes straight to the front left and front right balanced outputs, and unbalanced signals go only to the
unbalanced outputs. Signals from balanced or unbalanced analog sources do not appear at the digital
outputs of the C 2.
For best playback performance from digital sources (such as CD, DVD, and DAT players or
recorders), connect them to the digital inputs of the C 2. It usually makes little difference
whether you use coaxial connections (black RCA jacks on the C 2) or optical connections (small
square Toslink connectors); however, if the cables must make sharp bends, optical cables
should not be used. Signals from the digital inputs also pass through the 24-bit digital-to-analog
converters in the C 2 to appear at its main analog outputs. When Toslink jacks are not in use,
they should be protected from dust with the small black plastic plugs supplied.
Note: Although analog audio cables have the same plugs as coaxial digital cables, they do not
have the proper characteristics to transfer digital signals properly. However, composite-video
cables (which usually have yellow plugs) can be used.
The following table summarizes the relationships between the different types of input and
output in the C 2:
Note: Programmable Outputs can access the same sources as the Main Outputs.
1 = Available at the composite video “OSD” output jack; not available at the “No-OSD” output jack
General Rules When Connecting Sources to the C 2:
•
To avoid sudden blasts of noise (which can harm your speakers), make sure
the power cord of the C 2 is disconnected, or that its rear-panel power switch
is turned off (the “0” position).
•
Make sure all your cables are long enough so that they are not strained or
stretched when you pull the C 2 out to make or change connections.
•
Don’t use excessively long cables; they cost more money, get in your way,
and can reduce signal quality.
CONNECTING AUDIO AND VIDEO SOURCES AND RECORDERS
continued
38
Unbalanced Analog In Yes Yes Yes Yes No Yes
Balanced In – Normal Yes Yes Yes Yes No Yes
Balanced In – Bypass No Yes No No No No
Tape Monitor Play/In Yes Yes No No No No
Digital Inputs Yes Yes No No Yes No
7.1-Channel
Analog Inputs
Yes Yes Yes Yes No No
AUDIO MAIN BALANCED RECORD 1 & TAPE DIGITAL ZONE
INPUTS/OUTPUTS OUTPUTS OUTPUTS RECORD 2 MONITOR OUTPUTS OUTPUT
OUTPUTS REC/OUT
Available From
Composite Video In Yes No No Yes No Yes
S-video In Yes 1 Yes No No Yes No
Component Video In No No Yes No No No
VIDEO COMPOSITE S-VIDEO COMPONENT COMPOSITE S-VIDEO ZONE
INPUTS/OUTPUTS VIDEO OUTPUTS VIDEO VIDEO REC/OUT OUTPUT
OUTPUTS OUTPUT REC/OUT
Available From