Patio Heater Instructions
OZGLOW HE 40 Hi/Lo
INSTALLATION INSTRUCTIONS - OPTION A (Continued)
5.
Run a 15mm copper tube or
15mm
nominal bore gas line inside the channel
of the frame and connect to the heater.
For natural gas models, fit the regulator
supplied in the gas line.
6.
Run the wiring down the inside of
the
frame and connect to the heater. The
wires in the side channel
must
be
covered by a heat protective material
for at least the area opposite the emitter
mesh and reflector. The red and black
wires on the heater are to go to the 24
VAC transformer and the yellow wires
are to be run to the high / low switch
(supplied by the installer).
This appliance is 24 VAC and the
transformer MUST be fitted.
Refer to warnings on page 4.
7.
Purge the fitting line and light the heater by turning the power on.
Lighting instructions are on the data plate (or refer to page 5).
8.
Check the burner pressure and adjust if necessary. Pressure details are
on the data plate (or refer to page 5).
© PARASOL HEATERS AUSTRALIA
+61 3 9549 4466 - Head 61 3 9546 6069
www.parasolheaters.com.au
Created on 24/09/2015
Page 12 of 18
