Paramount Pools Poolquip Lido, Инструкция по эксплуатации

Страница: 18 / 19

55. Commence running water into pool.
When you have approximately 25mm,
remove all floor creases by working
from the center to the wall. Remember
the more water over 25mm depth, the
more difficult it is to remove the creases.
VERTICAL
RAIL
JOINER
6
4
10
6
Do not install these items until the water level has
filled to just below the cut out positions in the
wall.
This will ensure the liner is cut with accuracy and
lines up easily to the metal cut-outs. reducing the
chances of unsightly wrinkles around these fittings.
Procedure - Paramount SP1500
Surface Skimmer
Hold the face plate in position through the cut
out, pierce the liner through the 15 bolt holes (1)
with a pointed spike to allow easy insertion d the
bolts.
Place one gasket on the inside of the face plate
and carefully insert bolts through. starting with
the four comers.
Place 2nd gasket (2) on outside of the wall and
then position actual skimmer box on the
protruding bolts. Ensure both gaskets have
seated properly, fit nuts to bolts and tighten
all 15 evenly.
Finally trim the liner around Inside of the
skimmer mouth, check skimmer basket is
locked and position deck lid.
EYEBALLS
Cut the liner to the hole size in the wall. Ensure
you cut it the same size or slightly smaller,
but
not larger.
Fit a gasket to the eyeball, then position eyeball
through the liner, then wall. Thread lock nut on
and tighten.
Proceed with the connecting of the plumbing.
Do not cover pipes until you have run water
through the entire filtration system, checking all
joins for leaks.
Wall
Liner
LIDO POOL
DO NOT DRAIN THE POOL.
Leave the pool filled throughout
the year, suitably protected
by a winterizing programme.
Unless the liner has been
damaged and cannot be
repaired on site, draining the
pool unnecessarily could result
in excess liner shrinkage which
is not covered under warranty.
If the liner has been damaged
repairs should be carried out
preferably with the liner in place
and removed only if replacement
is necessary. If a liner is to be
returned under warranty, please
contact your local store prior to
shipment. Returned liners must
be thoroughly cleaned and dried
inside and out. Mark the damaged
area with a black grease pencil.
The liner should be folded neatly
and packed securely into a
cardboard box marked with return
name and address. The pool can be
drained by using the vacuum and
diverting the return line, or by
siphoning.
Replacement Parts: Replacement
parts can be ordered from your
local store. Include the pool size,
part name and number when
ordering.
16. FIT VERTICAL
SUPPORT
17. FIT TOP RAILS/SEATS
18. FIT SURFACE SKIMMER
AND EYEBALL RETURNS
MAINTENANCE
Use vaseline on inside to slide connector to assist
assembly.