Paramount Pools Poolquip Lido, Инструкция по эксплуатации

Страница: 17 / 19

46. Before spreading sand over floor unscrew
pressure plates and fill base channel and
pressure plate areas with sand to prevent
any movement.
Re-install pressure plates
Note: It is very important that this step is
completed correctly. The sand has to be
packed tightly to eliminate movement of
pressure plate when walked upon.
48. Spread the sand over the entire floor area
to an even depth of approximately 50mm
making sure you have 50mm of sand over
the pressure plate.
49. Compact the sand on the floor by
tramping or rolling until a footprint no
longer shows.
50. Installation of liner
Remove all seats and connector plates.
51. Place the pool pad (GROUND COVER)
over the entire floor area and hold it in
position by taping in to the pool wall.
53. Position the liner so that wall-floor
seam is an equal distance from pool
wall at both ends and sides. The liner
has several seams running across the
pool floor, which must be straight and
parallel to side frames.
52. Unroll the liner in the center of the pool
with the smooth weld up. (The liner is
easier to install if left unrolled in the sun
to warm and soften) .
54. Pull the liner wall up over the pool wall
and hold in place with plastic coping strips. (7)
Note: Remove footwear before walking
on liner.
LIDO POOL
12. PREPARE COVE
AND SPREAD
SAND ON BASE
13. INSTALL GROUND
COVER
14. INSTALL LINER
15. CHECK & SECURE
LINER
47. Build up an even cove of firm sand or
earth around the wall of the pool
approximately 150mm and pack firmly.