TOOLS AND ACCESSORIES
*
BEFORE ASSEMBLY
: Remove the Reflector
Center Cap which comes packaged underneath
the heater Base and is protected by a styrofoam
insert.
5
CAUTION
PARTS LIST
1. reflector Center Cap
2. reflector Panels
3. Head Assembly
4. Burner Support
5. Tank Housing
6. Post/Post Support plate
7. Hose/Regulator
8. Post Supports
9. Base
10. Wheel Bracket
11. Wheel axle
12. Wheel
13. Grounding Brackets
14. Tank Chain
1
2
3
4
5
6
7
8
9
10
11
12
13
14
•
DO NOT operate the heater in an explosive environment Keep this appliance away from areas where you
have stored gas or other vapors and flammable liquids.
•
Before use verify that no parts are damaged, inspect gas hose.
•
Never modify, this appliance in any way or it will void the warranty.
•
Never use the heater without the reflector shield .
•
Respect minimum clearance from combustibles top 36", sides 24".
•
Always place heater on a leveled, stable and hard surface.
•
Only use this heater outdoors.
•
Never clean with abrasive, corrosive or flammable cleaners.
•
Do not paint the heater or any of its parts.
•
When fully assembled please perform a leak test, and every time you disconnect the hose, before lighting
up the heater.
•
A leak test must be performed before operating the appliance. To perform a leak test, use a 50/50 mix of each
water and soap in a spray bottle.
•
NEVER LEAK TEST with an open flame or while smoking.
•
The gas cylinder must be closed at all times when not using the heater.
•
Children and adults should be made aware of hot surfaces on the heater.
•
Clothing and other accessories or objects are not to be hung or laid on the heater or near it to dry.
•
Do not obstruct the ventilation opening on cylinder cover.
•
Installation, maintenance and repair of this heater should always be performed by a qualified qas technician.
TOOLS AND EQUIPMENT REQUIRED
10 and 13mm wrench,
Philips screwdriver, medium blade
Leak test solution: MIX 50/50 water and soap
1 Propane cylinder (not supplied), with QCC 1 valve
