[NOTE: Before attaching the LED connectors to the LED control box, you must insert 8 - AA batteries (NOT
included) by sliding the top of the LED control box off to release the top. Once the top is removed, insert the
batteries and then replace the top by sliding it back down on the box.] Connect both sets of connectors and
control LED feature with On/Off switch located on LED control box.
ASSEMBLY AND INSTRUCTIONS
9
8.
While supporting heater, tilt the Head and Upper Post Assembly (B) and screw in
the 3 M8x66 Stud Bolts (BB) into the holes on top of the Head Assembly. Slide the
assembled Reflector over the 3 bolts that now extend from the Head Assembly. Use
the 3 M8 Wing Nuts (DD) and 3 M8 Washers (FF) to secure the assembled Reflector
to the Head Assembly of the heater. Once you have tightened the Wing Nuts,
return the heater to an upright position.
Hardware Used : 3 x BB, Stud Bolt with Nut
3 x DD, Wing Nut M8
3 x FF, Washer M8
9. Connecting the LED feature:
This heater comes equipped with LED rope lights preassembled in the base and Post support plate (See Fig.1 and
2 below):
8
base with LED rope lights
Post support plate with LED rope lights
LED connector
Fig.1
Fig.2
