STEP 8 : OPERATION & STORAGE
8 -1 OPERATION
1. Open the gas cylinder valve
3. Depress control knob and then push the RED ignitor button to ignite the
main burner. Repeat until main burner ignites. Keep the control knob fully
depressed for an additional 30 seconds after burner ignites and then release.
turn the control knob counter clockwise.
6. Wait 5 minutes before re-lighting the unit
NOTE : Main burner may also be lit using a MATCH
Caution: Be aware of gas build-up when lighting with a match - especially after
holding down control knob. If you smell gas, WAIT 5 minutes for gas to dissipate
before lighting.
Manual Lighting
: place a match through any of the large holes at the bottom of
the burner unit while following the lighting procedures above.
WARNING : Read the installation, operation, and maintenance instructions
thoroughly. BEFORE operating, installing or servicing this equipment, improper
use, adjustment, service and/or maintenance can cause serious injury or
damage to your property.
Minimum Clearance to adjacent combustible surfaces is as follows :
Sides – 24’’ Top – 36’’
The Gas Supply Must be turned OFF at the LP Gas Cylinder when this
appliance is not in use.
OPERATION & STORAGE - 11
** NOTICE **
During the FIRST TIME use
only. It is normal to expe-
rience a small amount of
smoke coming from the re-
coating applied during the
manufacturing process.
Calibration Mark
Ignitor
button
OFF
Large
Flame
Small
Flame
** Think Safety**
After appliance shuts
down Do NOT touch or
move unit for at least
30 minutes. This allows
proper cooling of the
heater components.
