OPERATION INSTRUCTIONS
1. To extinguish burner depress control knob and continue to turn it clockwise to OFF.
2. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.
Burner will display tongues of blue and yellow flame. These flames should not be yellow or produce thick
black smoke, which would indicate an obstruction of airflow through the burners. The flame should be
blue with straight yellow tops. If excessive yellow flame is detected, turn off heater and consult
“Troubleshooting”on page 15
1. Turn control knob to OFF
2. Repeat the "Lighting”steps on prior page
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this
fire pit. Holding in the control know for more than 10
seconds before igniting the gas will cause a ball of
flame upon ignition
When fire pit is ON
Shut Down
Re-lighting
CARE AND MAINTENANCE
To enjoy years of outstanding performance from your fire pit, make sure you perform the following
maintenance activities on a regular basis
Keep exterior surfaces clean
1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around the burner dry at all times. Do not submerge
the control valve assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
a. Keep the appliance area clear and free from combustible materials, gasoline and other
flammable vapors and liquids
b. Do not obstruct the flow of combustion and ventilation air.
c. Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
3. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs
of possible blockage include
WARNING
FOR YOUR SAFETY
Fire pit will be hot after use. Handle with extreme care.
WARNING
FOR YOUR SAFETY
·
tes
Do NOT touch or move fire pit for at least 45 minu
after use
·
Reflector is hot to the touch.
·
Allow reflector to cool before touching.
15
